Product Instructions: 80 series (91-97) Land Cruiser Attic Rack

80 Series Land Cruiser- Attic Rack

Product Overview

The Attic Rack consists of 5 main pieces- The two large halves of the rack, the connector that joins the two halves and the mounting brackets. The two halves will be fastened to the center connector on the bench, then the brackets will be installed in the vehicle. Lastly, the rack will be set on the vehicle brackets and fastened down.

Tool list-

10mm socket
7/16 socket
Ratchet or bit driver
7/16 open end wrench
Phillips screwdriver
Small screwdriver or pick

Step 1: Lay out parts and hardware as shown

The (4) m6 bolts (longer flange head bolts) are to fasten the brackets to the vehicle, the other (12 sets) of ¼-20 bolts, nuts and washers are to assemble the Attic.

Step 2: Assemble the Attic

Set the two halves of the attic on top of the center connector and align the bolt holes. Install all hardware and tighten. The recommended tightening sequence is to tighten the bottom fasteners first, then the sides.

Step 3: Install mounting brackets in the vehicle.

Remove the factory grab handle by removing the small plastic fastener covers with a small screwdriver or pick and then removing the phillips head screws. Install the mounting bracket using the m6 bolts. These brackets are slotted for small amounts of adjustment. If you would like a little more room on top of the attic push the bracket down, If your goal is to have more room below for something such as clearance for a larger tire while using our interior tire carrier you might want to push the bracket all the way up.

Step 4: Install the assembled Attic

After both mounting brackets are installed and tightened you can set the completed attic on top of the mounting brackets. Install and tighten using the remaining fasteners.