3rd Gen 4Runner Interior Tire Carrier

$568.00
$568.00
Tire Carrier Side
Molle Panel

Description

  • Fits 3rd generation Toyota 4Runner (96-02)
  • Driver or Passenger side available
  • Adjustable from a 285/70 up to a 35″ tire *see full description for disclaimer*
  • Molle panel ready (sold separately, add on at any time)
  • Comes in raw steel finish
  • All mounting hardware and handle grips included
  • Cut, formed, bent and welded in house in the USA
  • Built to order, 1 week lead time in most cases

Description

Its here! Our popular Interior Tire Carrier has drifted over from the Land Cruiser world and is now available for the 3rd Gen (1996-2002) 4Runner.

The carrier is available for either driver or passenger side (specify at checkout), it mounts through the floor and wheel well using (8) 10mm bolts and heavy duty backing plates. Install is easy- The carrier position is located on the body by installing a bolt from the factory tie down point in the rear and then drilling all other required holes. It can hold up to a 35″ tire and still have full function of your rear seat. Tire carriers come in raw steel

Molle panel is sold separately and must be added on at checkout! All carriers come threaded to accept the molle panel and it can be purchased and upgraded at any time. 

Built to order, lead times apply! 1 week in most cases. 

What’s in the box?

  • Tire carrier base
  • Threaded handle
  • Handle grips
  • Urethane wheel hub cone
  • All needed hardware and backing plates

Important stuff-

***Disclaimers***

  • Want to run a 36″ perhaps a 37″ tire? It may be possible depending on your specific tire measurements to do so. The carrier will need to be custom mounted further forward than intended and the rear seat will no longer be usable. I make no claims to the fitment of any tire larger than 35″, Mount at your own risk.
  • Tire Carriers are for offroad use only, They are not crash tested and are to be used at your own risk!

Molle panel add on-

Molle panel upgrade for 3rd gen 4Runner Interior Tire Carrier. – Every Tire carrier sold comes ready to accept this panel with no modification necessary.

Having this accessory added to the back side of your tire carrier gives you a great solution to utilize wasted space in your rig. It makes a good sturdy surface to mount your on board air compressor (measure your compressor with fittings installed first! modification to interior panel may be necessary depending on application) (ARB twin shown fits dependent on hose fitting used), Medical bag for quick access, fire extinguisher, axe and anything else you can fit back there. There is approximately 5″ of room between the molle panel and the interior panel and roughly 8″ at the top portion between the window.

Comes with standard 1″x1.5″ molle pattern and a slot pattern that is 2″ on center. 2 Upper vertical slots are perfect for mounting an axe or other long items. The panel sides and top are specifically recessed from the tube to allow the use of tube mounted accessories such as a fire extinguisher etc.

Comes as a kit with: Panel, mounting brackets and hardware

Sold in raw steel.